![]() ![]() Now that your shelf holes have been drilled, you can insert the pins and place the shelves on top! Just count down the same number on all four rows so your shelf is level. The set pin will keep it in place after the first hole is drilled. You won't be able to clamp the jig down in the back, so just hold it steady as you drill the first hole. Start from the same end (either the top or the bottom) and drill the same holes. If you're working with a pre-assembled cabinet, remove the hook from the jig when drilling the holes in the back so it's flat against the surface. Start from the same end at the back of the cabinet The set pin holds the jig at the right spacing as you move it down the cabinet side. Shelf pin holes are typically kept at a consistent spacing of 32 mm on center (even if you're working in imperial measurements). Use the set pin to keep the hole spacing consistent Drill through the jig's holes using the drill bit until it hits the depth stop collar. I usually skip the first three or four holes, but make sure you drill at least one! You'll need this hole for the set pin on the next batch. In general, you'll want at least six inches to get your hand in there comfortably. You typically don't need shelf pin holes all the way down the side of your cabinet sides, unless you plan on storing paper or other flat items. If you're working with flat pieces, align the edge of the jig with the edge of the board on one end. On an assembled cabinet, just butt it up to the inside of the top or bottom. There's a removable hook piece on the jig that makes it easy to keep the correct spacing from the front edge.Ĭlamp the jig in place to prevent it from moving. Clamp the shelf pin jig in placeĪlign the jig with the front edge of the cabinet side where you want to drill the holes. Reset the depth to ¾" material by inserting the bit into the back of the jig and tightening the screw. You can adjust the height of the stop collar if necessary (such as when working with thinner stock) with the set screw. The Kreg shelf pin jig comes with a drill bit and stop collar that is already set to the correct depth for ¾" material. You don't want to start at the bottom on one side and at the top on the other! I always mark the top with a piece of painter's tape. But if your cabinet is in pieces, make sure to mark which is the top on each of the side pieces. If your cabinet is already assembled, it's easy to know which end is up. I had to rebuild the previous entertainment center because our PS5 didn't fit! Always start from the same spot I used my Kreg shelf pin jig on this DIY game console shelf so I could easily adjust them to fit new console sizes. These jigs come with drill guide holes, ensuring that your bit stays straight and the holes are evenly spaced and the correct depth. ![]() There are several jigs available on the market, such as the Kreg shelf pin jig. The tape holds the fibers of the wood in place, so you get a cleaner hole! How to use a Kreg shelf pin jig painter's tape! Before you start drilling holes, place a strip of painter's tape over the area. Luckily, there's an easy way to prevent this issue. This is a common issue when using melamine or particleboard, but can also occur on cheaper plywood. Nothing makes a DIY project scream "homemade" more than chipped edges around holes. Drill a hole with the chosen bit and insert the shelf pin to ensure the fit is secure and snug.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |